RZ/A2M SUB Board RTK79210XXB00000BE 2. Function specifications
R20UT4398EJ0100 Rev.1.00 2-12
2018.10.11
Table 2.2.11 List of RZ/A2M Pin Function Selections Used on the RTK79210XXB00000BE (11)
PH_5 / HM_RSTO# / NAF2 /
ET1_EXOUT / MTIC5U /
IRQ5
Connects to Ethernet PHY2 (U28)
Connects to NAND flash memory
(U31)
PK_5 / GTETRGA / NAF1 /
WDTOVF/PERROUT /
MTCLKA
Connects to NAND flash memory
(U31)
Connects to SDVcc through a resistor
Connects to the test point (TP1 on the
CPU board)
P6_7 / WE0/DQML /
DRP03 / LCD0_TCON3 /
DACK0 / CC2_RD0
Connects to DRP connector (CN2)
PJ_4 / TRACEDATA2 /
NAF1 / VRAMMON4 /
CTS1 / SSIBCK3
Connects to UDI connector (CN5 on
the CPU board)
PJ_5 / TRACEDATA3 /
NAF2 / OVRCUR0 /
MTIOC1A / SSIFS2 / IRQ4
Connects to UDI connector (CN5 on
the CPU board)
Connects to microSD card slot (CN1
on the CPU board)
Connects to SDVcc through a resistor
Connects to SDVcc through a resistor
Connects to SDVcc through a resistor
Connects to GND through a resistor
P3_5 /
ET1_RXD1/RMII1_RXD1 /
FCLE / CC2_RA0 /
CAN0TX_DATARATE_EN /
SSL00
Connects to Ethernet PHY2 (U28)
Connects to NAND flash memory
(U31)
P3_2 /
ET1_CRS/RMII1_CRSDV /
FRE / CC1_RA1 /
CAN1RX_DATARATE_EN /
MOSI2
Connects to Ethernet PHY2 (U28)
Connects to NAND flash memory
(U31)
Connects to microSD card slot (CN1
on the CPU board)
Connects to microSD card slot (CN1
on the CPU board)
[Note] : 3.3V power source, : 1.8V power source, : 1.2V power source, : 3.3V or 1.8V power source,
: GND
Red text CPU board setting display.