3.7
System
installation
1
4
Installing the batteries
NOTES:
See Section 5, "Maintenance" for a list of suitable battery types.
If dead batteries are inadvertently inserted into the probe, the LEDs will remain a constant red.
Do not allow coolant or debris to enter the battery compartment.When inserting batteries, check that
the battery polarity is correct.
After inserting the batteries the LEDs will display the current probe settings (for details, see Section 4,
"Trigger Logic™").
2
3
Please remove the
battery isolation
device from the
battery compartment
before use.
X
To Next Page
Loading...
