OMP400 installation guide
5.2
Maintenance
1
2
CAUTIONS:
Do not leave exhausted batteries in the probe.
When changing batteries, do not allow coolant or debris to enter the battery compartment.
When changing batteries, check that the battery polarity is correct.
Take care to avoid damaging the battery cassette gasket.
Only use specied batteries.
Changing the batteries
CAUTION: Please dispose of exhausted batteries in accordance with local regulations. Never dispose
of batteries in a re.
NOTES:
After removing the old batteries, wait more than 5 seconds before inserting the new batteries.
Do not mix new and used batteries or battery types, as this will result in reduced life and damage to
the batteries.
Always ensure that the cassette gasket and mating surfaces are clean and free from dirt before reassembly.
If dead batteries are inadvertently inserted into the probe, the LEDs will remain a constant red.
To Next Page
Loading...
Need help?
General
