EC DECLARATION OF CONFORMITY
Renishaw plc declares that the products: -
Name: PH10T, PH10M, PH10MQ
Description: Motorised probe heads
Part numbers: A-1025-0050
A-1025-1520
A-1036-0001
Serial numbers: As shown by the declaration sent with the product
have been manufactured in conformity with the following standards: -
BS EN 61326-1:2006/ Electrical equipment for measurement, control and
laboratory use - EMC requirements.
BS EN ISO 12100-1:2003 Safety of machinery - Basic concepts, general
BS EN ISO 12100-2:2003 principles for design.
Reports demonstrating compliance have been compiled and are available on request,
in paper format, to market surveillance authorities.
Person authorised to compile the Renishaw technical file and issue the declaration of
conformity is:
Mark Acres
Compliance Manager
Renishaw plc, New Mills, Wotton-under-Edge
Gloucestershire, GL12 8JR, United Kingdom
This product must not be put into service until the machinery into which it is to be
incorporated has been declared in conformity with the provisions of the Machinery
Directive - 2006/42/EC.