EN - Warnings
Pinch hazards exist between moving parts and between moving and static parts. Do
not hold the probe head during movements, or when manually changing a probe.
Beware of unexpected movement. The user should remain outside the full working
envelope of probe head/extension/probe combinations.
In all applications involving the use of machine tools or CMMs, eye protection is
recommended.
There are normally no user-serviceable parts inside Renishaw mains-powered units.
Return defective units to an authorised Renishaw Customer Service Centre.
Replace blown fuses with new components of the same type. Refer to the safety
information in the relevant product documentation.
For instructions regarding the safe cleaning of Renishaw products, refer to the
maintenance information in the relevant product documentation.
Remove power before performing any maintenance operations.
Refer to the machine supplier’s operating instructions.
It is the machine supplier’s responsibility to ensure that the user is made aware of
any hazards involved in operation, including those mentioned in Renishaw product
documentation, and to ensure that adequate guards and safety interlocks are provided.
Under certain circumstances the probe signal may falsely indicate a probe-seated
condition. Do not rely on probe signals to stop machine movement.
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
The expected method of providing an emergency stop for Renishaw products is to
remove power.
Safety
To Next Page
Loading...
