Renu Electronics FlexiLogics series - Precautions During Operation

Maintenance
127
Doc No: UMAN\FL\0110
Rev. No.: 1.02B
9.1 Precautions during operation
When the FlexiLogics units are in operation, you should pay attention to the following points:
(1) The programming cable can be plugged or unplugged while the FlexiLogics units are in operation. When
you try to do it, do not touch the connector pins. This may cause malfunction of the FlexiLogics units
owing to static electricity.
(2) Do not plug nor unplug the expansion cable during power on. This can cause damage to the equipment.
Furthermore, to avoid malfunction of the FlexiLogics owing to static electricity, do not touch the cable
ends.
(3) Do not touch any terminals while the FlexiLogics unit is in operation, even if the terminals are not live
parts. This may cause malfunction of the FlexiLogics unit owing to static electricity.
(4) Do not touch the expansion connector pins while the FlexiLogics base model is in operation. This may
cause malfunction of the units owing to static electricity.
Fix the expansion connector cover if the expansion connector is not used.
(5) Do not insert your finger into the option card slot while the FlexiLogics unit is in operation. This may
cause malfunction of the FlexiLogics unit owing to static electricity.
Fix the option card slot cover securely.
(6) Do not insert your finger into the expansion rack’s ventilation hole during power on. This may cause
malfunction of the FlexiLogics unit owing to static electricity.