Reymsa HFC Series - Figure A-25: Upper Section 1 & 2 for a Quadruple Fan Tower on Plane

REYMSA COOLING TOWERS, INC.
www.reymsa.com
The
All-Fiberglass
Cooling Towers
11
HORIZONTAL FLANGES
UPPER SECTION VERTICAL
FLANGES
Figure A-25: Upper Section 1 & 2 for quadruple fan tower on plane
K. Now with the two upper sections together, proceeds to bolt down and secure horizontal anges with the
stainless steel nut and bolts sets supplied by REYMSA. See Figure A-25.
Installation
L. Identify each fan duct, they are labeled with a number on the inside of the lower edge. For a correct
installation, this number must match the number on the corresponding receiving ange. Place fan duct 1
on the corresponding receiving ange on top of section 1 of the tower (see Figure A-26); make sure the
bolt holes and the marks inside the fan duct and receiving ange are aligned (Figure A-27). Secure it
with the stainless steel nut and bolt sets supplied by REYMSA. There are two different types of receiving
anges, either one has its own assembly pieces (see Table A-4 to verify the Type of receiving ange of
your tower).