Message Causes Solutions
Misfeed: Tray 2 Paper has been jammed in the
paper tray.
Remove the jammed paper. See
page 336 "Removing Paper Jams".
Net Communication
Error
Connection with the server was
lost while sending or receiving
data.
Contact the network administrator.
Network is not Ready A scanned file could not be sent
because the machine has not
received IP address information
from the DHCP server
completely.
Wait until the machine receives the IP
address information completely, and then
try the operation again.
On Hook or Stop key The machine has been off-hook
for an extended period of time.
Put down the handset phone or press the
[Clear/Stop] key.
Out of Paper: X The indicated tray has run out of
paper.
Load paper to the indicated tray. See
page 44 "Loading Paper".
Please Restart the
Machine
The machine needs to be
restarted.
Turn off the power, and then turn it back
on.
Printing stopped due
to low voltage.
The supplied voltage is too low
to run the machine's functions.
Check the power source. If devices that
consume much electricity, such as halogen
heaters or electric heaters, are connected
to the same outlet as the machine, plug
them into separate outlets.
Replace Required
Soon:Print Cartr.
The print cartridge is almost
empty.
Prepare a new print cartridge.
Replacement
Required: Print Cartr.
The print cartridge is almost
empty.
The machine has run out of
toner.
Replace the print cartridge. See page 313
"Replacing the Print Cartridge".
RX Communication
Error
A reception error occurred, and
the fax could not be received
correctly.
If possible, contact the sender of the fax
and ask them to resend it.
Scan (NW)
Disconnected
A scanned file could not be sent
because the Ethernet cable was
not connected properly.
Reconnect the Ethernet cable properly,
and then try the operation again.
10. Troubleshooting
330
To Next Page
Loading...
