Message Causes Solutions
Low voltg stopped
print
The supplied voltage is too low
to run the machine's functions.
Check the power source. If devices that
consume much electricity, such as halogen
heaters or electric heaters, are connected
to the same outlet as the machine, plug
them into separate outlets.
Memory Overflow The number of fax jobs in
memory (unsent or unprinted
faxes) has reached maximum,
so new jobs cannot be stored.
Wait until pending jobs have been
transmitted or printed.
Memory Overflow The data is too large or
complex to print.
• Select [600 × 600 dpi] in
[Resolution] under [Printer Features]
to reduce the size of data. See
page 232 "Printer Features Settings".
• If using the PCL6 printer driver, set
[Resolution] in the [Print Quality] tab
to [600 × 600 dpi].
Memory Overflow • The machine's memory
reached capacity while
scanning the first page of
the original to store a fax
job in memory before
transmission.
• The machine's memory
reached capacity while
storing a fax in memory in
Memory Transmission
mode.
Resend the fax in parts as several smaller
individual faxes, or send at a lower
resolution.
Misfeed: Duplex Unit
Remove Paper
Paper has been jammed in the
duplex unit.
Remove the jammed paper. See
page 336 "Removing Paper Jams".
Misfeed: BypassTray Paper has been jammed in the
bypass tray.
Remove the jammed paper. See
page 336 "Removing Paper Jams".
Misfeed: Standard
Tray
Paper has been jammed in the
paper exit area.
Remove the jammed paper. See
page 336 "Removing Paper Jams".
Misfeed: Tray 1 Paper has been jammed in the
tray 1 paper input area.
Remove the jammed paper. See
page 336 "Removing Paper Jams".
Error and Status Messages on the Screen
329
To Next Page
Loading...
