REMARKS
154
7
Maintaining Your Machine
If the exposure glass or document
feeder is dirty, you might not be able
to make clear copies. Clean these
parts when you find them dirty.
❖
❖❖
❖ Cleaning the machine
Wipe the machine with a soft,
damp cloth. Then, wipe it with a
dry cloth to remove the water.
Important
❒ Do not use chemical cleaner or or-
ganic solvents, such as thinner or
benzene. If they get into the ma-
chine or melt plastic parts, a failure
might occur.
❒ Do not clean parts other than those
specified in this manual. Such
parts should be cleaned by your
service representative.
Cleaning the Exposure Glass
A
AA
A
Clean 1 and 2.
Cleaning the Document Feeder
A
AA
A
Clean the white sheet of the docu-
ment feeder.
B
BB
B
Pull the lever.
C
CC
C
Wipe the scanning glass.
MartiniC1_GBzen2_FM.book Page 154 Friday, April 19, 2002 2:18 PM
To Next Page
Loading...
