Appendix
98
7
NetBEUI
A Click [NetBEUI].
B Type the name into the [Computer Name] box and comment into the [Com-
ment] box.
• In the [Computer Name] box, type the name that helps you to identify
printers using the NetBEUI protocol. The factory default name consists
of “RNP” and the last 3 bytes of the MAC address on the Network In-
terface Board. For example, when the MAC address is
00:00:74:62:7D:D5, the factory default name is “RNP627DD5”. A maxi-
mum of 13 characters consisting of uppercase English letters, numeric,
or symbols (except "*+,/:;<=>?[\]|. and space) can be used. No name is
permitted if the prefix is “RNP”. You must avoid the duplication of the
same name on a network.
• In the [Comment] box, type any comment on printers in under 31 charac-
ters.
F
FF
F
Click [Apply].
The setting is transmitted to the printer.
G
GG
G
Exit the Web browser.
Displaying the Status of Printer
You can view the status of printers using SmartNetMonitor for Admin, Smart-
NetMonitor for Client, or Web browser.
SmartNetMonitor for Admin
A
AA
A
Run SmartNetMonitor for Admin.
B
BB
B
Click the [Group] menu, point to [Search Device], and then select [TCP/IP] or
[IPX/SPX].
The status of printers is indicated with an icon in the list.
Note
❒ For more information about the status icons, see SmartNetMonitor for Ad-
min Help.
C
CC
C
Getting further information, click the desired printer to select from the list,
and then click [Open] on the [Device] menu.
The status of the printer is displayed on the dialog box.
Note
❒ For more information about each item on the dialog box, see Help.
To Next Page
Loading...
