Setting Up a Client Computer
33
2
Setting Up a Client Computer
This section describes the procedures for setting up a client in a network that
uses Windows 2000/XP, Windows NT Server or Windows NT Workstation as a
print server.
When using a Windows 2000/XP or Windows NT print server, select a shared
printer on Windows 2000/XP or Windows NT.
Limitation
❒ When using a print server connected to the machine with SmartNetMonitor
for Client, you cannot use Recovery Printing and Parallel Printing.
Note
❒ This section assumes that the client has already been configured to communi-
cate with a Windows 2000/XP or Windows NT print server. Do not begin the
following procedure until the client has been set up and configured correctly.
❒ When using Windows NT 4.0 as the print server, make sure to install the Win-
dows NT 4.0 printer driver before connecting the print server. There is a Win-
dows NT 4.0 printer driver on the CD-ROM labeled “Printer Drivers and
Utilities”.
Use the [Printers] window to set up the printer.
A
AA
A
Click [Start], point to [Settings], and then click [Printers].
B
BB
B
Double-click the [Add Printer] icon.
This launches the Add Printer Wizard.
C
CC
C
Click [Next >].
Windows 2000
Windows 2000/XP or
Windows NT Print Server
To Next Page
Loading...
