Error & Status Messages on the Display Panel
31
4
Machine Status and Configuration
You can check the machine status and configuration using telnet or UNIX.
❖
❖❖
❖ telnet
Use the info or status command.
❖
❖❖
❖ UNIX
Use the lpr or lpstat command, or stat or info parameter of rsh, rcp, or ftp.
Reference
For more information, see “Remote Maintenance by Telnet (mshell)”, the
Network Printing Guide provided as a PDF file on the CD-ROM labeled
“Operating Instructions”.
machine status
Status Description
Ready Normal operation
Panel Off Mode Panel Off mode
Energy Saver Mode Energy Saver mode
Warming Up Warming up
Error: Parallel I/F Parallel interface board error
Error: NVRAM Contents of the memory unit are damaged.
Error: DIMM DIMM has a problem.
Error: HDD Hard disk drive has a problem.
Error: Ethernet Ethernet board has a problem.
Error: IEEE1394 IEEE 1394 board has a problem.
Error: IEEE802.11b Card IEEE802.11b card is not inserted when the ma-
chine is turned on or has been removed.
Error: IEEE802.11b Card or Board IEEE802.11b card or board has a problem.
Error: USB I/F USB interface board has a problem.
Low: Toner Toner is almost empty.
Replace Cleaning Web Clearing web is soon full.
Nearly Full: Waste Toner Waste toner is soon full.
In Use: Staple Unit Staple unit is in use.
In Use: Input Tray Paper tray is in use.
Malfunction: Tray X Paper cannot be fed from tray X. An error has
occurred in tray X. (X is the number of the
tray.)
To Next Page
Loading...
