Troubleshooting
30
4
❖
❖❖
❖ Alert Messages
Messages/Second messages Description Solution
Hole punch receptacle is full.
Open finisher cover and emp-
ty punch receptacle.
Hole punch receptacle is full. Empty the punch receptacle.
dStaple (centre) is almost
empty.
There are few staples remain-
ing in the stapler.
Load more staples.
NV-RAM has a problem. An error has occurred in the
optional memory unit.
Turn the main power switch
off, and on. If the message ap-
pears again, call your sales or
service representative.
Parallel I/F board has a prob-
lem.
An error has occurred in the
parallel interface board.
Contact your sales or service
representative.
Paper in staple tray. Open fin-
isher cover and remove pa-
per.
There is paper remaining in-
side the finisher.
Remove the paper remaining
inside the finisher.
Selected paper tray is in use
for another function. Please
wait.
The specified paper tray is in
use by another function such
as the copier function.
Wait until the other function
has finished using the speci-
fied paper tray.
Shift tray has a problem. Call
service representative.
A malfunction occurs when
using the shift function.
Contact your sales or service
representative.
dStaple is almost empty. There are few staples remain-
ing.
Load more staples.
Staple unit is in use for anoth-
er function. Please wait.
The staple unit is in use by an-
other function such as the cop-
ier function.
Wait until the other function
has finished using the staple
unit.
USB has a problem. An error occurred in the USB
interface board.
Contact your sales or service
representative.
To Next Page
Loading...
