Ricoh Aficio 1060 - Monitoring and Configuring the Printer; Changing Names and Comments

Monitoring and Configuring the Printer
95
7
Monitoring and Configuring the Printer
Changing Names and Comments
You can change printer names and make a comment on printers to easily iden-
tify the printers listed on SmartNetMonitor for Client.
The following utilities are used to change printer names and comments.
❖
❖❖
❖ SmartNetMonitor for Admin
Allows you to change names and comments when the TCP/IP protocol or
IPX/SPX protocol is available. You can install SmartNetMonitor for Admin
from the CD-ROM that comes with the printer. For more information about
installing SmartNetMonitor for Admin, see p.60 “Installing SmartNetMoni-
tor for Admin”.
❖
❖❖
❖ Web Browser
Allows you to change names and comments when the TCP/IP protocol is
available.
Note
❒ Each of the names, in a TCP/IP protocol form (printer name) and in a Net-
BEUI protocol form, is changed individually. Comments are, however,
common to both of them.
❒ The factory default name consists of “RNP” and the last 3 bytes of the
MAC address on the Network Interface Board. For example, when the
MAC address is 00:00:74:62:7D:D5, the factory default name is
“RNP627DD5”. Comments are not configured.
SmartNetMonitor for Admin
A
AA
A
Run SmartNetMonitor for Admin.
B
BB
B
Click the [Group] menu, point to [Search Device], and select [TCP/IP] or
[IPX/SPX].
A list of printers appears.
Note
❒ Select the protocol of the printer you want to change its configuration.
C
CC
C
On the list, select a printer whose Network Interface Board you want to
change its configuration.
D
DD
D
From the [Tools] menu, select [NIB Setup Tool].
The NIB Setup Tool starts up.