Using SmartNetMonitor for Admin
89
7
Managing the E-mail Information
Limitation
❒ If you use E-mail Management Tool, you need a computer and devices that
communicate with TCP/IP (HTTP).
A
AA
A
Run SmartNetMonitor for Admin.
B
BB
B
Click the [Group] menu, point to [Search Device], and then select [TCP/IP] or
[IPX/SPX].
A list of printer appears.
Note
❒ Select the protocol of the printer you want to change its configuration.
C
CC
C
On the list, select a printer whose statistics information you want to man-
age.
D
DD
D
From the [Tools] menu, select [E-mail Management Tool].
The screen that prompts you to type a password appears.
E
EE
E
Type the password, and then click [OK].
Note
❒ The factory default password is “password”.
The E-mail Management Tool starts up.
For more information about using the User Management Tool, see SmartNet-
Monitor for Admin Help.
Configuring the Energy Save Mode
A
AA
A
Run SmartNetMonitor for Admin.
B
BB
B
Click the [Group] menu, point to [Search Device], and then select [TCP/IP] or
[IPX/SPX].
A list of printer appears.
Note
❒ Select the protocol of the printer you want to change its configuration.
C
CC
C
Click [Group], point to [Energy Save Mode], and select any energy saver mode
from the menu that appears.
For more information about settings, see SmartNetMonitor for Admin Help.
Note
❒ When you point to [Set Individually], [Timer Settings] is not displayed.
To Next Page
Loading...
Need help?
General
