Copier Features
31
3
❖ Duplex Margin
Specify left margin on the back side of copies, and top margin on the back
side. Select [Top Margin] or [Left Margin], and then set the required value.
• Top Margin: 0-50mm, 0"-2"
• Left Margin: 0-50mm, 0"-2"
The default setting is 5 mm (Metric version) / 0.2 inch (Inch version).
❖ Rotate Sort
Specify whether or not to select rotate sort when the {Sort} key (finisher not
installed), or {Sort/Staple} key (finisher installed) is pressed.
The default setting is Off.
When you select [On], you can select [Rotate Sort].
You cannot use the bypass tray with this function.
If you select [Off] when the finisher is not installed, only the Sort function is
available when you press the {Sort} key.
❖ Rotate Sort:Auto Continue
If you select [Off] when the paper tray in use runs out of paper, the machine
stops, allowing you to add paper so all copies can be rotate-sorted.
The default setting is Off.
❖ Auto Sort
You can set whether Auto Sort is [On] or [Off] when the machine is turned on,
reset, or modes are cleared.
The default setting is On.
❖ Letterhead Setting
If you select [On] for this function, the machine rotates the image correctly.
The default setting is Off.
Orientation-fixed (top to bottom) or two-sided paper might not print correct-
ly, depending on how the originals and paper are placed.
Reference
p.4 “Accessing User Tools”.
“Original Type Setting”, Copy Reference
“Adjusting Image Density”, Copy Reference
“Selecting Copy Paper”, Copy Reference
“Orientation-Fixed Paper or Two-Sided paper”, Troubleshooting
To Next Page
Loading...
