Ricoh Aficio MP 2500 - Configuring a Windows XP Computer; Configuring a Windows Server 2003 Computer

Windows Configuration
6
1
Configuring a Windows XP Computer
Follow the procedure below to configure a Windows XP computer to use
TCP/IP.
A On the [Start] menu, click [Control Panel], and then click [Network Connections].
B Click [Network Connections], and then double-click [Local Area Connection].
C On the [General] tab, click [Properties].
D Select [Internet Protocol (TCP/IP)] in the [This connection uses the following items]
box on the [General] tab.
If TCP/IP is not installed, click [Install] on the [General] tab to install it. For de-
tails about installing TCP/IP, see Windows XP Help.
E Click [Properties].
F Configure TCP/IP using the appropriate IP address, subnet mask, and oth-
er settings.
Check with the network administrator that the settings are correct.
Configuring a Windows Server 2003 computer
Follow the procedure below to configure a Windows Server 2003 computer to
use TCP/IP.
A On the [Start] menu, point to [Control Panel], point to [Network Connections],
and then click [Local Area Connection].
B On the [General] tab, click [Properties].
C Select [Internet Protocol (TCP/IP)] in the [This connection uses the following items]
box on the [General] tab.
If TCP/IP is not installed, click [Install] on the [General] tab to install it. For de-
tails about installing TCP/IP, see Windows Server 2003 Help.
D Click [Properties].
E Configure TCP/IP using the appropriate IP address, subnet mask, and oth-
er settings.
Check with the network administrator that the settings are correct.