EasyManua.ls Logo

Ricoh Aficio MP 2500 - Page 190

Ricoh Aficio MP 2500
452 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting When Using the Facsimile Function
32
3
Reception
Cannot cancel a Memo-
ry Transmission.
The document is being sent or it is
in standby.
Press the {Clear/Stop} key. See
“Canceling a Transmission”, Fac-
simile Reference.
Cannot cancel an Im-
mediate Transmission.
-Press the {Clear/Stop} key. See
“Canceling a Transmission”, Fac-
simile Reference.
Cannot cancel Internet
Fax transmission.
-Press the {Clear/Stop} key. See
“Canceling a Transmission”, Fac-
simile Reference.
Canceling Internet Fax transmis-
sion is possible only during scan-
ning. It is impossible during
communication.
Although a group spec-
ification was set for the
following, reception
was not possible.
Forwarding, Forward-
ing of Special Sender,
E-mail TX Result, rout-
ing e-mail received via
SMTP.
The number of specified destina-
tions exceeds the maximum
number that can be specified as a
group.
A maximum of 100 parties can be
specified for a group. Check if
there are over the specified num-
bers registered in the address
book. If a group was registered in
another group, transmission is
canceled but an error message
does not appear. See “Registering
Names to a Group”, General Set-
tings Guide.
Problem Cause Solution
The machine failed to print
received fax documents.
If this happened when the Re-
ceive File indicator was lit, the pa-
per or toner might have run out,
making printing impossible.
Load paper into the paper
tray.
•Add toner.
See “Substitute Reception”, Fac-
simile Reference.
The machine failed to print
received fax documents.
When the B Load Paper indica-
tor is lit.
Load paper into the paper tray.
See p.87 “Loading Paper”.
Reception is impossi-
ble, but transmission is
possible.
The toner has run out. Replace the toner bottle. See p.98
“Replacing Toner”.
Reception is possible, but
transmission is impossible.
The terminal adaptor setting is in-
correct.
Check the setting.
Transmission is possible,
but reception is impossible.
The terminal adaptor setting is in-
correct.
Check the setting.
Problem Cause Solution

Table of Contents

Other manuals for Ricoh Aficio MP 2500

Related product manuals