Box Settings
149
4
Programming a password
This section describes how to program a password for the Personal Box.
A Press [Password].
B Enter a password, and then press [OK].
If you make a mistake, press [Clear] or the {Clear/Stop} key before pressing
[OK], and then try again.
C Re-enter the password, and then press [OK].
To change the password after pressing [OK], press [Change] and repeat steps
B
and
C
, or press [Cancel] and repeat from step
A
.
D Press [OK].
Programming an End Receiver
This section describes how to program an End Receiver of the Personal Box.
A Press [Receiver].
B Select a destination using the destination list, and then press [OK].
Press the key shown on the right side of the screen to switch the destination
among fax number, Internet Fax address and IP-Fax address.
To Next Page
Loading...
