SEP Code Reception
Enable this function to perform SEP Code Reception.
• This function is not available with Internet Fax and e-mail.
• To perform SEP Code Reception, a SEP Code must be set in [Adv.Features], the Address Book, or
Keystroke Programs in advance. Otherwise, even if “SEP Code Reception” is set to on, reception is
not performed.
• When you select a destination that has a registered SEP Code from the Address Book, if “SEP Code
Reception” is set to off, the SEP Code is not appended and transmission is in standard fax mode.
1. Press [TX Mode].
2. Select [Option Setting].
3. Press [SEP Code Reception] to highlight it.
To cancel SEP Code Reception, press [SEP Code Reception] again.
4. Press [OK] twice.
5. Specify the destination, and then press the [Start] key.
• For details about specifying SEP Codes, see the following:
Transmission Options
175
To Next Page
Loading...
