Problem Cause Solution
[Connect Copy] is not
displayed.
The sub-machine's main
power is off.
Turn on the sub-machine's main power.
[Connect Copy] is not
displayed.
Functions that cannot be used
with Connect Copy are
selected on the main machine
(such as storing or copying
the first page of a document
in the Document Server).
Cancel the functions selected on the
main machine.
[Connect Copy] is not
displayed.
The main machine is in
Interrupt mode.
Press the [Interrupt] key on the sub-
machine to cancel Interrupt mode.
[Connect Copy] is not
displayed.
The [Connect Copy Key
Display] setting is off.
Select [Display] for the [Connect Copy
Key Display] setting.
[Connect Copy] is not
displayed.
The cable connecting the two
machines is damaged.
Contact your service representative.
[Connect Copy] is not
displayed.
The is lit. Follow the instructions displayed.
[Connect Copy] appears
faded.
Functions that cannot be used
with Connect Copy have
been set.
Press the [Clear Modes] key to clear the
settings.
If Connect Copy Is Canceled
This section describes causes and remedies when Connect Copy is canceled.
Problem Cause Solution
The machine cancels
Connect Copy.
The main machine's main
power is off, or the operation
switch has been pressed.
Turn on the sub-machine's main power
or operation switch, and then press
[Connect Copy].
When You Cannot Make Copies As Wanted
43
To Next Page
Loading...
Need help?
General
