System
This section describes the user tools in the System menu under Printer Features.
Print Error Report
Select this to have an error report printed when a printer or memory error occurs.
The default setting is [Off].
Auto Continue
You can select this to enable Auto Continue. When it is On, printing continues after a system error
occurs.
The default setting is [Off].
Memory Overflow
Select this to have a memory overflow error report printed.
The default setting is [Do not print].
Rotate by 180 Degrees
Specify whether to rotate the print image 180 degrees relative to the paper orientation.
The default setting is [Off].
Duplex
You can select to have print on both sides of each page.
The default setting is [Off].
Copies
You can specify the number of print sets. This setting is disabled if the number of pages to print has
been specified with the printer driver or another command.
The number of copies can be specified from 1 to 999 by increments of one.
The default setting is “1” copies.
Blank Page Print
You can select whether or not to print blank pages.
The default setting is [On].
Pages that match one of the following conditions are identified as blank.
• There are no images.
• There are images but they are outside the printable area.
• There are only blank characters.
Sub Paper Size
You can enable the Auto Substitute Paper Size (A4, LT) feature.
The default setting is [Auto].
System
115
To Next Page
Loading...
Need help?
General
