PictBridge Printing
Follow the procedure below to start PictBridge printing on this machine.
• Do not disconnect the USB cable while data is being sent. If you do, printing will fail.
• Use the USB cable bundled to your digital camera.
1. Check the machine and the digital camera are both switched on.
2. Connect a USB cable between the USB host interface on the machine and the digital camera.
The Data In indicator on the machine blinks for several seconds and "PctBrdg" is displayed on the
machine's control panel. This indicates the machine recognizes the digital camera as a PictBridge
device.
3. On your digital camera, select the images you want to print, and specify the printing
conditions.
The machine receives settings from the digital camera and starts printing.
• Since printing conditions are specified on the digital camera, specifiable meters depend on the
particular digital camera. For details, see your digital camera's manual.
• Some digital cameras require settings for manual PictBridge operation. For details, see your digital
camera's manual.
4. Direct Printing from a Digital Camera (PictBridge)
86
To Next Page
Loading...
Need help?
General
