Removing Punch Waste
115
7
C Reinstall the punch waste box.
D Close the front cover of the Booklet Finisher.
“
Hole Punch Receptacle is full.” disappears.
Note
❒ If you do not reinstall the punch waste box in Step
C
, the “Hole Punch Re-
ceptacle is full.” message continues to be displayed.
❒ If the message is still displayed, reinstall the punch waste box.
❒ The message “
Hole Punch Receptacle is full.” may appear even
when the punch waste box is not yet full. If this happens, the position of
the punch waste box (indicated by the arrow as shown) may be blocked by
punch waste. Remove the punch waste.
AMJ030S
AMJ006S
To Next Page
Loading...
