When You Cannot Make Copies as Wanted
23
2
Staples are wrongly po-
sitioned.
Originals are not set correctly. Check the correct position to
place the originals. See "Staple",
Copy/Document Server Refer-
ence.
You cannot combine
several functions.
Selected functions cannot be used
together.
Check the combination of func-
tions and make the settings again.
See "Function Compatibility",
Copy/Document Server Refer-
ence.
When sorting, the pag-
es are divided into two
blocks.
The memory became full in the
middle of sorting and the pages
were delivered in two blocks.
You can interrupt copying when
the memory becomes full. See
"Memory Full Auto Scan Re-
start", General Settings Guide.
Paper does not output
during printing with
stapling.
When you stop printing while us-
ing the staple function, papers
not stapled during printing may
be left in the staple unit.
Press the {Clear modes} key and
cancel copy settings, including
stapling.
The copy is grayed out
or a text pattern ap-
pears in the back-
ground of the copy.
You have copied a copy-guarded
document protected from unau-
thorized copying.
Check the document. See "Using
[Data Security for Copying] ", Printer
Reference.
Print is slanted. The side fences in the paper feed
tray is not locked.
Make sure the side fence is
locked. See p.84 “Changing the
Paper Size”.
Print is slanted. The paper is feeding in at a slant. Load the paper correctly. See p.79
“Loading Paper”.
Print is slanted. The front cover is open. Make sure the right and lower
right covers are properly closed.
Problem Cause Solution
To Next Page
Loading...
