Troubleshooting When Using the Facsimile Function
30
3
Updating the
destination
list... Please
wait. Specified
destination(s)
or sender's name
has been
cleared.
The destination list is being up-
dated from the network using
SmartDeviceMonitor for Admin
or Web Image Monitor. Depend-
ing on the number of destinations
to be updated, there may be some
delay before you can resume op-
eration. Operation is not possible
while this message is displayed.
Wait until the message disap-
pears. Do not switch off the pow-
er while this message is
displayed.
The selected
file(s) con-
tained file(s)
without access
privileges. Only
file(s) with ac-
cess privileges
will be deleted.
You tried to delete a document
for which you do not have per-
mission to delete.
Only the administrator can delete
this document. Contact the ad-
ministrator if you want to delete a
document for which you do not
have permission to delete.
Connection with
LDAP server has
failed. Check
the server sta-
tus.
A network error has occurred
and connection has failed.
Try the operation once more. If
the message is stillshown, the
network may be crowded. Check
the information of [System Set-
tings]. See "System Settings", Gen-
eral Settings Guide.
LDAP server au-
thentication has
failed. Check
the settings.
A network error has occurred
and connection has failed.
Make settings correctly for the
user name and the password for
LDAP server authentication.
Exceeded max.
No. of display
search results.
Max.:
The number of search results has
exceeded the maximum number
of items that can be displayed.
Search again after changing the
search conditions.
Exceeded time
limit for LDAP
server search.
Check the server
status.
A network error has occurred
and connection has failed.
Try the operation once more. If
the message is stillshown, the
network may be crowded.Check
the information of [System Set-
tings]. See "System Settings", Gen-
eral Settings Guide.
The specified
group contains
some destina-
tion(s) that do
not have access
privileges. Do
you want to se-
lect only the
privileged des-
tination(s)?
The specified group contains
some destinations for sending by
e-mail and some destinations for
sending by Scan to Folder.
To select destinations for sending
by email, press [Select] for the
message displayed on the e-mail
screen. To select destination for
sending by Scan to Folder, press
[Select] for the message displayed
on the Scan to Folder screen.
Message Cause Solution
To Next Page
Loading...
