Troubleshooting When Using the Facsimile Function
38
3
❖ Printing
Problem Cause Solution
Print is slanted. The tray's side fences might not
be locked.
Check the side fences are locked.
See p.84 “Changing the Paper
Size”.
Print is slanted. The paper is fed at a slant. Load the paper correctly. See p.79
“Loading Paper”.
Print is slanted. The front cover is open. Make sure the right and lower
right covers are properly closed.
Misfeeds occur frequently.
The number of feeding in exceeds
the capacity of the machine.
Load paper only as high as the
upper limit markings on the side
side fences of the paper tray or
bypass tray. See "Copy Paper",
About This Machine.
Misfeeds occur frequently.
The paper is damp. Use paper that has been stored in
the recommended temperature
and humidity condition. See
"Copy Paper", About This Ma-
chine.
Misfeeds occur frequently.
The paper is too thick or too thin. Use recommended paper. See
"Copy Paper", About This Ma-
chine.
Misfeeds occur frequently.
The copy paper is wrinkled or
has been folded/creased.
Use recommended paper.Use pa-
per that has been stored in the
recommended temperature and
humidity condition. See "Copy
Paper", About This Machine.
Copy paper becomes
creased.
Printed paper is being used. Use recommended paper. See
"Copy Paper", About This Ma-
chine.
Copy paper becomes
creased.
The paper is damp. Use paper that has been stored in
the recommended temperature
and humidity condition. See
"Copy Paper", About This Ma-
chine.
Copy paper becomes
creased.
The paper is too thin. Use recommended paper. See
"Copy Paper", About This Ma-
chine.
Images are only partial-
ly printed.
The paper is damp. Use paper that has been stored in
the recommended temperature
and humidity condition. See
"Copy Paper", About This Ma-
chine.
Black lines appear on
the print produced at
the destination.
The exposure glass or scanning
glass is dirty.
Clean them. See p.121 “Maintain-
ing Your Machine”.
To Next Page
Loading...
