When You Cannot Send or Receive Fax Messages as Wanted
39
3
Background of received
images appears dirty.
Images from the back of
the page appear.
Image density is too high. Adjust scan density. See "Image
Density (Contrast)", Facsimile
Reference.
Printed or sent images
are spotty.
The ADF, exposure glass or scan-
ning glass is dirty.
Clean them. See p.121 “Maintain-
ing Your Machine”.
Make sure that ink or correction
fluid is dry before placing origi-
nals.
Received image is too
light.
When using moist, rough, or
processed paper, areas of print
may not be fully reproduced.
Only use recommended paper.
See "Copy Paper", About This
Machine.
Received image is too
light.
When D is blinking, toner is be-
ginning to run out.
Add toner. See p.90 “Adding
Toner”.
Received image is too
light.
• The image density has been
set too low.
• The original of the transmit-
ted fax was printed on paper
that is too thin.
• Increase the scanning density.
See "Image Density (Con-
trast)", Facsimile Reference.
• Ask the sender to reprint the
original on thicker paper and
fax it again.
Problem Cause Solution
To Next Page
Loading...
