Ricoh Aficio MP C4502 General Settings Guide

Box Settings
163
4
Programming End Receivers
This section describes how to program End Receivers of Transfer Box.
A Select an End Receiver.
Press [Receiving Stn 1-5].
You can store five Receiving Station.
B Specify End Receivers with Destination keys, and then press [OK].
You can change the display to the fax destination, Internet fax destination,
and IP-Fax destination using the key on the left side of the display.
A reception station can also be registered as a group destination. In such a
case, a maximum of 500 parties including End Receiver 1-5 can be specified
in a group.
To register another End Receiver, repeat from step
A
.
Programming a password
This section describes how to program a password for the Transfer Box.
A Press [Password].
B Enter a password, and then press [OK].
If you make a mistake, press [Clear] or the {Clear/Stop} key before pressing
[OK], and then try again.
C Re-enter the password, and then press [OK].
To change the password after pressing [OK], press [Change] and repeat steps
B
and
C
, or press [Cancel] and repeat from step
A
.

Ricoh Aficio MP C4502 Specifications

General

Print Technology	Laser
Maximum Print Resolution	1200 x 1200 dpi
Maximum Paper Capacity	4, 400 sheets
Automatic Duplexing	Yes
Maximum Scan Resolution	600 dpi
Fax Capability	Optional
Maximum Paper Size	12" x 18"
Memory (Standard)	1.5 GB
Hard Drive	250 GB
Copy Resolution	600 x 600 dpi
Print Speed	45 ppm
Standard Paper Capacity	1, 200 sheets
Scanner Type	Flatbed, ADF
Network Connectivity	Ethernet
Functions	Print, Copy, Scan
Copy Speed	Up to 45 ppm (Black/Color)
Fax Speed	33.6 kbps
Operating System Compatibility	Windows, Mac, Linux