15. Specify the path.
For details about how to specify the path manually, see "To locate the SMB folder manually".
For details about how to specify the path using Browse Network, see "To locate the SMB folder using
Browse Network".
16. Press [Connection Test] to check the path is set correctly.
17. Press [Exit].
If the connection test fails, check the settings, and then try again.
18. Press [OK].
19. Press [Exit].
20. Press the [User Tools/Counter] key.
• To register the name, see "Registering Names".
• You can enter up to 64 characters for the user name.
• You can enter up to 64 characters for the password.
• You can enter a path using up to 128 characters.
• If User Authentication is specified, contact your administrator.
• p.138 "Registering Names"
• p.156 "To locate the SMB folder manually"
• p.157 "To locate the SMB folder using Browse Network"w
To locate the SMB folder manually
This section describes how to locate the SMB folder manually.
1. Press [Change] under "Path".
2. Enter the path where the folder is located.
6. Registering Addresses and Users for Scanner Functions
156
To Next Page
Loading...
