Ricoh J006 - Page 222

SM 8-22 J001/J003
8.2.6 ERR-992
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
SERVICE TECHNICIAN (ST) and/or
NATIONAL RECLAMATION CENTER
(NRC) ACTION
Waste ink tank error.
Confirm that the printer issued an alert
(prompting the operator to replace the internal
unit) before this error occurred, and if this is the
case, the printer requires servicing.
Waste ink tank full.
Damage.
Use the scroll bar on the Status Monitor screen to
scroll down and confirm the SC number.
Confirm that the printer issued an alert to prompt
the user to replace the waste ink tank before this
error occurred.
(1) On the Status Monitor screen, use the
vertical scroll bar to scroll down and confirm
the number of the SC code.
Use the scroll bar on the Status Monitor screen to
scroll down and confirm the SC number.
(2) Confirm that the printer issued an alert
pro
mpting the user to replace the internal unit
before this error occurred.
Waste ink tank full. Confirm that the printer issued an alert to prompt
the user to replace the waste ink tank before this
error occurred.
(3) ST Descriptions
3-1 Operation impaired by other causes.
1. The waste ink tank below the maintenance unit is
full.
2. The ink suction vent on the left side is dirty or full.
3. Maintenance unit is dirty or defective.
4. The nozzle covers of the carriage are dirty.
5. Harness disconnected, damaged.
6. The ink waste tank full sensor is damaged.
1.
Replace the ink waste tank below the
maintenance unit (ST) (NRC).
2. Clean or replace the ink suction vent
on the left side.
3. Clean or replace the maintenance
unit.
4. Clean the nozzle covers of the
carriage.
5. Check harness, replace (NRC).
Note: Please do Steps 1 to 4.
6.
Replace the ink waste tank below the
maintenance unit (ST) (NRC).
8.2.7 ERR-990
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
SERVICE TECHNICIAN (ST) and/or
NATIONAL RECLAMATION CENTER
(NRC) ACTION
Ink waste tank full feeler is out of position.
Switch the printer off and on. If the SC error
occurs again, the printer requires servicing.
Insufficient suction.
Pressure plate missing or bent.
Damage.
Use the scroll bar on the Status Monitor screen to
scroll down and confirm the SC number.
Switch the printer off/on.
(1) On the Status Monitor screen, use the
vertical scroll bar to scroll down and confirm
the number of the SC code.
Use the scroll bar on the Status Monitor screen to
scroll down and confirm the SC number.
(2) Switch the printer off, and then switch it on
again.
Switch the printer off/on.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA