SP Tables
J007/J010/J011 5-8 SM
Do this SP when mist build-up in the MID area of the paper in use is clogging the
print head nozzles during printing with any paper in any mode, except: normal
paper in High Speed (Draft) mode and glossy paper in High Quality mode. This
SP setting is linked to the charge pitch tables (SP1200 to SP1231). The IDs are
determined by the temperature and humidity. There are 4 IDs associated with the
SP numbers listed below.
SP1109：ID1
SP1111：ID2
SP1113：ID3
SP1115：ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj3: Simplex
1116 CHG:W1:EDGE:9 LE/TE: Mj3:ID1
1118 CHG:W1:EDGE:10 LE/TE: Mj3:ID2
1120 CHG:W1:EDGE:11 LE/TE: Mj3:ID3
1122 CHG:W1:EDGE:12 LE/TE: Mj3:ID4
Use this SP to set the pitch width of the charge applied to the LE/TE of paper in
future print modes (currently under development). Do this SP when the paper in
use is causing mist to build up near the leading and trailing edges of the sheets
and causing the print heads to clog. This SP setting is linked to the charge pitch
tables (SP1200 to SP1231). The IDs are determined by the temperature and
humidity. There are 4 IDs associated with the SP numbers listed below:
SP1116：ID1
SP1118：ID2
SP1120：ID3
SP1122：ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj3: Simplex
1117 CHG:W1:MID:9 MID: Mj3:ID1
1119 CHG:W1:MID:10 MID: Mj3:ID2
1121 CHG:W1:MID:11 MID: Mj3:ID3
1123 CHG:W1:MID:12 MID: Mj3:ID4
This SP code is currently under development.
Use this SP to set the pitch width of the charge applied to the MID area of paper
in future print modes except: normal paper in High Speed (Draft) mode and
glossy paper in High Quality Mode. Do this SP when the paper is use is causing
mist to build up in the MID area and clogging the print head nozzles. This SP
setting is linked to the charge pitch tables (SP1200 to SP1231).
The IDs are determined by the temperature and humidity. There are 4 IDs
associated with the SP numbers listed below:
SP1117：ID1
SP1119：ID2
To Next Page
Loading...
