SP Tables
SM 5-9 J007/J010/J011
J007/J010
J011
SP1121：ID3
SP1123：ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj4: Simplex
1124 CHG:W1:EDGE:13 LE/TE: Mj4:ID1
1126 CHG:W1:EDGE:14 LE/TE: Mj4:ID2
1128 CHG:W1:EDGE:15 LE/TE: Mj4:ID3
1130 CHG:W1:EDGE:16 LE/TE: Mj4:ID4
Use this SP to set the pitch width of the charge applied to the LE/TE of glossy
paper for printing in the High Quality mode. Do this SP when the mist build-up
near the leading and trailing edges of glossy paper is causing the print heads to
clog during printing in High Quality mode.
This SP setting is linked to the charge pitch tables (SP1200 to SP1231). The IDs
are determined by the temperature and humidity. There are 4 IDs associated with
the SP numbers listed below:
SP1124：ID1
SP1126：ID2
SP1128：ID3
SP1130：ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj4: Simplex
1125 CHG:W1:MID:13 MID: Mj4:ID1
1127 CHG:W1:MID:14 MID: Mj4:ID2
1129 CHG:W1:MID:15 MID: Mj4:ID3
1131 CHG:W1:MID:16 MID: Mj4:ID4
Use this SP to set the pitch width of the charge applied to the MID area of the
paper when printing on glossy paper in the High Quality mode. Do this SP when
mist build-up in the MID area of glossy paper is causing the print heads to clog
during printing in High Quality mode.
This SP setting is linked to the charge pitch tables (SP1200 to SP1231). The IDs
are determined by the temperature and humidity. There are 4 IDs associated with
the SP numbers listed below:
SP1125：ID1
SP1127：ID2
SP1129：ID3
SP1131：ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj1 : Duplex
1132 CHG:W2:EDGE:1 LE/TE: Mj1:ID1
To Next Page
Loading...
