SP Tables
J007/J010/J011 5-10 SM
1134 CHG:W2:EDGE:2 LE/TE: Mj1:ID2
1136 CHG:W2:EDGE:3 LE/TE: Mj1:ID3
1138 CHG:W1:EDGE:4 LE/TE: Mj1:ID4
Use this SP to set the pitch width of the charge applied to the LE/TE on the back
side of normal paper during duplex printing in the High Speed (Draft) mode. Do
this SP when mist build-up near the leading and trailing edges on the back sides
of the paper during duplex printing in the High Speed (Draft) mode is clogging the
print head nozzles. This SP setting is linked to the charge pitch tables (SP1200
to SP1231). The IDs are determined by the temperature and humidity. There are
4 IDs associated with the SP numbers listed below:
SP1132：ID1
SP1134：ID2
SP1136：ID3
SP1138：ID4
[0 to 255/0/1/0.1 mm]
1133 CHG:W2:MID:1 MID: Mj1:ID1
1135 CHG:W2:MID:2 MID: Mj1:ID2
1137 CHG:W2:MID:3 MID: Mj1:ID3
1139 CHG:W1:MID:4 MID: Mj1:ID4
Use this SP to set the pitch width of the charge applied to the MID area on the
2nd side of normal paper (excluding the LE/TE) for duplex printing in the High
Speed (Draft) mode. Do this SP when mist build-up in the MID area on the back
sides of the paper during duplex printing in the High Speed (Draft) mode is
clogging the print head nozzles. This SP setting is linked to the charge pitch
tables (SP1200 to SP1231). The IDs are determined by the temperature and
humidity. There are 4 IDs associated with the SP numbers listed below.
SP1133：ID1
SP1135：ID2
SP1137：ID3
SP1139：ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj2: Duplex
1140 CHG:W2:EDGE:5 LE/TE: Mj2:ID1
1142 CHG:W2:EDGE:6 LE/TE: Mj2:ID2
1144 CHG:W2:EDGE:7 LE/TE: Mj2:ID3
1146 CHG:W1:EDGE:8 LE/TE: Mj2:ID4
Use this SP to set the pitch width of the charge applied to the LE/TE on the 2nd
side of any paper in any print mode during duplex printing except: normal paper
in High Speed (Draft) mode and glossy paper in High Quality Mode. Do this SP
when mist build-up up near the leading and trailing edges on the 2nd side is
clogging the print head nozzles during duplex printing with any paper in any
To Next Page
Loading...
