SP Tables
SM 5-11 J007/J010/J011
J007/J010
J011
mode, except: normal paper in High Speed (Draft) mode and glossy paper in
High Quality mode. This SP setting is linked to the charge pitch tables (SP1200
to SP1231). The IDs are determined by the temperature and humidity. There are
4 IDs associated with the SP numbers listed below.
SP1140：ID1
SP1142：ID2
SP1144：ID3
SP1146：ID4
[0 to 255/0/1/0.1 mm]
1141 CHG:W2:MID:5 MID: Mj2:ID1
1143 CHG:W2:MID:6 MID: Mj2:ID2
1145 CHG:W2:MID:7 MID: Mj2:ID3
1147 CHG:W1:MID:8 MID: Mj2:ID4
Use this SP to set the pitch width of the charge applied to the MID area on the
2nd side of any paper in any print mode during duplex printing except: normal
paper in High Speed (Draft) mode and glossy paper in High Quality Mode. Do
this SP when mist build-up in the MID area on the 2nd side of the paper in use is
clogging the print head nozzles during duplex printing with any paper in any
mode, except: normal paper in High Speed (Draft) mode and glossy paper in
High Quality mode. This SP setting is linked to the charge pitch tables (SP1200
to SP1231).
The IDs are determined by the temperature and humidity. There are 4 IDs
associated with the SP numbers listed below:
SP1141：ID1
SP1143：ID2
SP1145：ID3
SP1147：ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj3: Duplex
1148 CHG:W2:EDGE:9 LE/TE: Mj3:ID1
1150 CHG:W2:EDGE:10 LE/TE: Mj3:ID2
1152 CHG:W2:EDGE:11 LE/TE: Mj3:ID3)
1154 CHG:W1:EDGE:12 LE/TE: Mj3:ID4
This SP is currently under development.
Use this SP to set the pitch width of the charge applied to the LE/TE on the 2nd
side of paper in future print modes (currently under development) during duplex
printing. Do this SP when mist build-up near the leading and trailing edges of the
2nd side is causing the print heads to clog. This SP setting is linked to the charge
pitch tables (SP1200 to SP1231). The IDs are determined by the temperature
and humidity. There are 4 IDs associated with the SP numbers listed below:
SP1148：ID1
SP1150：ID2
SP1152：ID3
To Next Page
Loading...
