SP Tables
J007/J010/J011 5-12 SM
SP1154：ID4
[0 to 255/0/1/0.1 mm]
1149 CHG:W2:MID:9 MID: Mj3:ID1
1151 CHG:W2:MID:10 MID: Mj3:ID2
1153 CHG:W2:MID:11 MID: Mj3:ID3
1155 CHG:W1:MID:12 MID: Mj3:ID4
This SP is currently under development.
Use this SP to set the pitch width of the charge applied to the MID area of the
2nd side of paper in future print modes (currently under development) during
duplex printing. Do this SP when mist build-up in the MID area is clogging the
print head nozzles. This SP setting is linked to the charge pitch tables (SP1200
to SP1231). The IDs are determined by the temperature and humidity. There are
4 IDs associated with the SP numbers listed below:
SP1149：ID1
SP1151：ID2
SP1153：ID3
SP1155：ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj4: Duplex
1156 CHG:W2:EDGE:13 LE/TE: Mj4:ID1
1158 CHG:W2:EDGE:14 LE/TE: Mj4:ID2
1160 CHG:W2:EDGE:15 LE/TE: Mj4:ID3
1162 CHG:W1:EDGE:16 LE/TE: Mj4:ID4
Use this SP to set the pitch width of the charge applied to the LE/TE on the 2nd
side of glossy paper for duplex printing in the High Quality mode. Do this SP
when the mist build-up near the leading and trailing edges on the 2nd side of
glossy paper is causing the print heads to clog during duplex printing in High
Quality mode. This SP setting is linked to the charge pitch tables (SP1200 to
SP1231). The IDs are determined by the temperature and humidity. There are 4
IDs associated with the SP numbers listed below:
SP1156：ID1
SP1158：ID2
SP1160：ID3
SP1162：ID4
[0 to 255/0/1/0.1 mm]
1157 CHG:W2:EDGE:13 MID: Mj4:ID1
1159 CHG:W2:EDGE:14 MID: Mj4:ID2
1161 CHG:W2:EDGE:15 MID: Mj4:ID3
1163 CHG:W1:EDGE:16 MID: Mj4:ID4
To Next Page
Loading...
