Maintaining Your Machine
If the exposure glass, exposure glass cover or ADF belt is dirty, copy clarity may be reduced. Clean
these parts if they are dirty.
Cleaning the machine
Wipe the machine with a soft, damp cloth. Then wipe it with a dry cloth to remove the water.
• Do not use chemical cleaner or organic solvents such as thinner or benzene. If such substances get
inside the machine or melt plastic parts, a failure might occur.
• Do not clean parts other than those explicitly specified in this manual. Other parts should only be
cleaned by your service representative.
Cleaning the Exposure Glass
To Next Page
Loading...
