Ricoh MP 6503 Series User Manual

When the LDAP Server Cannot Be Used
Message Cause Solution
"Connection with LDAP
server has failed. Check the
server status."
A network error has
occurred and connection
has failed.
Try the operation again. If the message
is still displayed, the network may be
busy.
Check the settings for LDAP server in
[System Settings]. For details about
settings for LDAP server, see
"Programming the LDAP server",
Connecting the Machine/ System
Settings.
"Exceeded time limit for
LDAP server search. Check
the server status."
A network error has
occurred and connection
has failed.
• Try the operation again. If the
message is still displayed, the
network may be busy.
• Check that the correct settings for
LDAP server are listed in
[Administrator Tools] of [System
Settings]. For details about LDAP
server, see "Programming the
LDAP server", Connecting the
Machine/ System Settings.
"LDAP server authentication
has failed. Check the
settings."
A network error has
occurred and connection
has failed.
Configure settings correctly for the user
name and the password for LDAP
server authentication.
10. Troubleshooting
238

Ricoh MP 6503 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Yes
Hard Disk Drive	320 GB
Power Source	220 - 240 V, 50/60 Hz
Supported Operating Systems	Windows, Mac OS, Linux
Monthly Duty Cycle	300, 000 pages
Type	Multifunction Printer
Print Speed	65 ppm
Connectivity	USB 2.0, Ethernet
Supported Paper Sizes	A3, A4, A5, B4, B5, Legal, Letter, Executive
First Print Speed	3.2 seconds
Paper Weight	52 - 300 gsm
Memory	2 GB
Scanning Speed	120 ipm
Scan Resolution	600 dpi