Ricoh MP 6503 Series User Manual

3. Make sure "Ready" appears on the screen.
4. Make sure [Immed. TX] is not highlighted.
5. Place the original into the ADF.
6. Make the scan settings such as scan size and resolution.
7. Configure the transmission settings such as [TX Mode] as necessary.
8. Specify a destination.
You can enter the destination's number or address directly or select from the Address Book by
pressing the destination key.
If you make a mistake, press [Clear], and then enter again.
9. When sending the same original to several destinations (broadcasting), specify the next
destination.
4. Fax
92

Ricoh MP 6503 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Yes
Hard Disk Drive	320 GB
Power Source	220 - 240 V, 50/60 Hz
Supported Operating Systems	Windows, Mac OS, Linux
Monthly Duty Cycle	300, 000 pages
Type	Multifunction Printer
Print Speed	65 ppm
Connectivity	USB 2.0, Ethernet
Supported Paper Sizes	A3, A4, A5, B4, B5, Legal, Letter, Executive
First Print Speed	3.2 seconds
Paper Weight	52 - 300 gsm
Memory	2 GB
Scanning Speed	120 ipm
Scan Resolution	600 dpi