Ricoh PRO C7200X - Page 101

1.SC Codes
97
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Malfunction due to an abnormal increase of the torque (caused by, for
example, overload due to remaining paper)
1. Check for remaining paper.
2. Perform an Output check for corresponding device.
3. Reconnect the connector.
4. Replace the Exit Path Entrance Motor.
5. Replace the drive unit.
6. Replace the PFB.
7. Replace the harness between PFB and Exit Path Entrance Motor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC526-
01
D
Grip Motor 1 (Tray 1) Rotation Error
SC526-
02
D
Grip Motor 2 (Tray 2) Rotation Error
2 seconds after motor startup, the motor lock error signal (LOCK signal) was
detected for 1200 msec or more.
 Grip Motor defective
 Harness broken
 Connector disconnect
 Replace the Grip Motor.
 Reconnect the connector.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC527-
01
D
Buffer Pass Unit: Cooling Fan Alarm 1
SC527-
02
D
Buffer Pass Unit: Cooling Fan Alarm 2
SC527-
03
D
Buffer Pass Unit: Cooling Fan Alarm 3
SC527-
04
D
Buffer Pass Unit: Cooling Fan Alarm 4
SC527-
05
D
Buffer Pass Unit: Exhaust Fan Alarm 1
SC527-
06
D
Buffer Pass Unit: Exhaust Fan Alarm 2
SC527-
D
Buffer Pass Unit: Exhaust Fan Alarm 3