Ricoh PRO C7200X - Page 161

1.SC Codes
157
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the Main Board.
 Resolve the mechanical failure for the Pre-stack mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-24
B
Exit Guide Motor Error
 Same as SC720-23
 Same as SC720-23
 Replace the Exit Guide Motor, reconnect the connectors.
 Replace the Exit Guide HP Sensor, reconnect the connectors.
 Replace the harness.
 Replace the Main Board.
 Resolve the mechanical failure for the exit guide mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-
25
D
Punch Motor Error
 After the punch motor started to operate, the punch was not detected at its
home position within specified number of pulses. (The first time: jam display,
the second time: SC)
 After the punch motor started to operate, the punch did not leave its home
position within specified number of pulses. (The first time: jam display, the
second time: SC)
 Motor defective
 Connecter disconnected
 Overload
 Home position sensor defective
 Replace the Punch Motor, reconnect the connectors.
 Replace the Punch Unit HP Sensor, reconnect the connectors.
 Replace the harness.
 Replace the Main Board.
 Resolve the mechanical failure for the punch mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-
26
D
Punch Junction Gate Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)