Ricoh PRO C7200X - Page 98

1.SC Codes
94
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Pressure Release HP Sensor
 Vertical Transport Exit Contact Motor
4. Replace the Main Control Board of the LCIT.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC512-
00
D
Rotary gate HP error
 Failed to detect "home position ON" during 2 rotations of the rotary gate after
the rotary gate stepping motor started to rotate.
 Failed to detect "home position OFF" during 2 rotations of the gate after
"home position ON" was detected
("2 rotations of the gate" is equal to 877 msec.)
 Rotary gate stepping motor disconnected or defective
 HP sensor disconnected or defective
 Malfunction due to overload
 Malfunction due to an error in the motor driver
 Actuator deformed, damaged, or improperly installed
 Cycle the main power switch off/on.
 Check or replace the corresponding motor, sensor, or harness.
 Check the drive part for the load, foreign matters, etc.
 Check the Actuator.
 Check or replace the PCB.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC514-00
D
Registration Shift Position Error
Home position on/off was not detected within the time limit.
 Shift Unit Motor connector disconnected and defective
 Shift Unit HP Sensor connector disconnected and defective
 Defective operation due to overload
 Defective operation due to the motor driver defective
 Shift Unit HP Sensor shield deformed/broken/incorrectly attached
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC515-00
D
CIS cleaning fan Error
During fan lock detection
 Overload
 Fan stopped by foreign object