Ricoh PRO C7200X - Page 99

1.SC Codes
95
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Connector disconnected
 Reconnect the connector
 Replace the CIS Cleaning Fan
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC516-
01
D
Exit JG home Position error
Detected when a change from Exit JG Position Sensor OFF to ON is not detected
within 400 msec after the Exit JG Motor starts to rotate.
 Exit JG Motor disconnected or defective
 Exit JG Position Sensor disconnected or defective
 Malfunction due to overload
 Malfunction due to an error in the motor driver
 Actuator deformed, damaged, or improperly installed
 Cycle the main power switch off/on.
 Check or replace the corresponding motor, sensor, or harness.
 Check the drive part for the load, foreign matters, etc.
 Check the Actuator.
 Check or replace the PCB.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC520-
00
D
Fusing Motor Error
 Error at motor startup
A lock signal was not detected for 1 second or longer after 1 second has
passed from the motor START signal switching ON.
 Error during motor running normally
A Lock signal was not detected for 1 second or longer during the motor
START signal being output.
 Motor connector disconnected
 Abnormal increase in Fusing Roller torque (overload due to the bearing lock,
etc.)
 Motor driver defective
 Reconnect the Fusing Motor connector
 Eliminate the overload in the Fuser Unit
 Replace the Fusing Motor