Ricoh Pro C751 EX - Adding Staples; Adding Staples to Finisher SR5030 and Booklet Finisher SR5040

Adding Staples
• Keep your hands clear of the booklet finisher tray when removing misfed paper, pulling out or
pushing in the finisher's staple unit. You can trap and injure your fingers if you do not.
• Stapling failures or jams may occur if you use a staple cartridge other than that recommended.
• If you cannot pull out the upper unit, there are staples remaining inside the cartridge. Use all the
staples, and do not add more.
• Refill the stapler according to the finisher type. Check the type if you are unsure. For details about
type of finisher, see p.40 "Options".
Adding Staples to Finisher SR5030 and Booklet Finisher SR5040
CAL004
Open the finisher
front cover.
Pull handle Rb18,
and then pull out
the staple unit.
Turn knob Rb19
counterclockwise
to rotate the staple unit.
Pull out the cartridge
lever.
Return the staple unit
to its original position.
Push in the cartridge
until it clicks.
Pull out the cartridge
gently.
Remove the empty
refill in the direction
of the arrow.
Push the new refill
into the cartridge until
it clicks.
Hold the lever, and
then push in the
cartridge.
Close the finisher
front cover.
3. Adding Toner and Staples
106
3