3. Carefully push the paper tray fully in.
• If you load a paper size that is not selected automatically, you will need to specify the paper size
with the control panel. For details, see p.80 "Changing to a Size That Is Not Automatically
Detected".
• The tray can hold up to 500 sheets of paper.
• Various sizes of paper can be loaded in tray 2 by adjusting the positions of side fences and end
fence. For details, see p.74 "Changing the Paper Size in Tray 2".
Loading Paper into the Wide Large Capacity Tray
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
paper bows, it might not feed in properly.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• If you load paper when only a few sheets of paper remain in the tray, multiple sheet feeding may
occur. Remove any remaining paper, stack them with the new sheets of paper, and then fan the
entire stack before loading it into the tray.
• Check the paper edges are aligned at the left side.
• When setting tab stock, always use the tab fence.
2. Adding Paper
66
To Next Page
Loading...
