Envelopes
This section describes loading envelopes.
• Misfeeds might occur depending on the length and shape of the flaps.
• Only envelopes that are at least 139.7 mm (5.5 inches) wide can be loaded in the Wide LCT.
To print on envelopes, load them into the Wide LCT, and be sure to specify the appropriate paper type.
To load envelopes in the Wide LCT, be sure to unfold their flaps and set them in the orientation with
print side face up.
If you are copying onto side-opening envelopes, be sure to unfold their flaps and set them in the
orientation with print side face up. Flaps must be at the right side of the Wide LCT.
• Be sure to specify the size of the envelope and flap size in Tray Paper Settings. For details, see
p.81 "Specifying Custom Size Paper".
• For details about the types of envelopes supported, consult your sales representative.
• When using envelopes, set “Paper Thickness” in “Tray Paper Settings” to the same value as two
sheets of the paper used for the envelopes.
2. Adding Paper
94
To Next Page
Loading...
