• You cannot switch modes in any of the following situations:
• When accessing User Tools / Inquiry
• When accessing Counter
• When accessing Tray Paper Settings
• During interrupt copying
• While scanning an original
• The copy display is set as the default screen when the machine is turned on. You can change this
default setting under Function Priority. See “System Settings”, Network and System Settings
Reference .
System Reset
After finishing a job, the machine waits a specified length of time and then restores its settings to the
default values specified under Function Priority. This function is called “System Reset”. For the procedure
for specifying default settings under Function Priority, see “System Settings”, Network and System
Settings Reference .
Changing Modes
53
To Next Page
Loading...
