Maintaining Your Machine
If the exposure glass or scanning glass is dirty, copy clarity may be reduced. Clean these parts if they
are dirty.
• When performing maintenance on the machine, always disconnect the power cord from the
wall outlet.
• Do not use chemical cleaners or organic solvents, such as thinner or benzene. If such substances
get inside the machine or melt plastic parts, a failure might occur.
• Do not clean parts other than those explicitly specified in this manual. Other parts should only be
cleaned by your service representative.
Cleaning the Machine
This section describes how to clean the machine.
Wipe the machine with a soft, dry cloth. If this does not remove the dirt, wipe the machine with a damp
and tightly wrung cloth. If a damp cloth still does not remove the dirt, try using a mild detergent. Wipe
the machine with a dry cloth to remove the moisture, after using a damp cloth.
Cleaning the Exposure Glass
1. Wipe the exposure glass and the scanning glass.
To Next Page
Loading...
