1. Elevator switch
The lamp of the elevator switch is blinking while the tray is going up, and keeps lit when it stops.
Press the elevator switch to move down the tray if you want to either add paper or remove jammed
ones.
• The tray can hold up to 500 sheets of paper.
• If you load paper that cannot be automatically detected, specify its size using the control panel. For
details, see p.80 "Changing to a Size That Is Not Automatically Detected".
• For details about using the multi bypass tray, see “Copying from the Multi Bypass Tray (Tray 6)”,
Copy and Document Server Reference
.
• The multi bypass tray is identified as tray 6.
Loading Orientation-Fixed Paper or Two-Sided Paper
Orientation-fixed (top to bottom) or two-sided paper (for example, letterhead paper, punched paper, or
copied paper) might not print correctly, depending on how the originals and paper are placed. Set
[Letterhead Setting] to [Yes] in [Input / Output] under [Copier / Document Server Features], and then
place the original and paper as shown below. For details about Letterhead Setting, see “Copier and
Document Server Features”, Copy and Document Server Reference .
Original Orientation
Exposure glass ADF
2. Adding Paper
72
To Next Page
Loading...
